Smeg SWM65EG - Manual (Page 11)

12
USING THE WASHING MACHINE
START BUTTON:
L
STOP
PROGRAMMER KNOB “STOP”:
OPTIONAL FUNCTIONS
When this button is pressed, the machine carries out a pre-wash cycle at a maxi-
mum temperature of 40°C. This function can only be used with the “ COTTON” and
“ SYNTHETIC” programmes.
N.B. When using this function, remember to put some detergent
in the pre-wash compartment too.
PREWASH:
SPIN EXCLUSION:
When this button is pressed, the machine carries out a wash cycle and stops before
spinning.
GB
The stop function resets the washing machine. If, for any reason, you want to change
the wash programme or add more washing to the load during the wash cycle, simply
place the programmer knob in position “ STOP”. Then re-position the knob on the new
programme and press the “ START” button. At this point, before the programme restarts,
any water in the machine will be drained.
Warning!! only use this function if strictly necessary and then only if the
programme to reset has been running f or a f ew minutes. Before open-
ing the door after a reset, wait 2 min utes for the locking mechanism to
release.
After having carried out all the operations described in points 1 to 6 in the paragraph
“
WASHING CYCLE” press this button and the washing machine will begin its washing
cycle. The relative LED will light up after 2-3 seconds, to indicate that the door is locked
and the program has started.
When this button is pressed, the machine carries out a wash cycle at the set
temperature but for longer. The button is active with “ COTTON” and “SYNTHETIC”
programmes.
ENERGETIC WASH:
SPIN LOAD IMBALANCE CONTROL:
This washing mac hine is equipped with a special electr onic control system f or correctly
balancing the wash load. Prior to each spin, the system ensures that the washing is e venly
distributed in the drum. If the washing is not evenly distributed, the f nal spin speed is reduced,
and if the load is very unbalanced, the spin is not effected.
If one of the f ollowing buttons is selected, the corresponding LED will s witch on. But if it has
been selected by mistake or you have changed your mind, simply press it a gain to cancel the
selection.
NB. The use of this function depends on the type of programme selected.
Consequently, if the wash programme does not include this function, the
button cannot be enabled (see “PROGRAMME TABLE”).