Savin 4018 - Manual (Page 59)

51
4. User Tools (Copier Features)
Accessing User Tools (Copier Features)
This section is for key operators in
charge of this machine. Key operators
can change or make default settings.
Note
❒ Be sure to quit User Tools and re-
turn to the initial copy display
when all settings are complete.
This section describes system set-
tings for the copier function.
❒ Selected settings are highlighted.
❒ Any changes made with User
Tools remain in effect even if the
main power switch or operation
switch is turned off, or the
{{{{Clear
Modes
}}}} key is pressed.
Reference
For details, see "User Tools (Sys-
tem Settings)", General Settings
Guide.
Changing Default Settings
Note
❒ If a key operator code is set, the
key operator code input display
appears before you can change the
default settings. For details about
access codes, see “Key Operator
Tools”, General Settings Guide.
AAAA
Press the
{{{{User Tools/Counter}}}} key.
BBBB
Select [Copier Features] using
{{{{U U U U}}}}
or
{{{{T T T T}}}}, and then press the {{{{OK}}}}
key.
CCCC
Select the menu using
{{{{U U U U}}}} or {{{{T T T T}}}},
and then press the
{{{{OK}}}} key.
DDDD
Change settings by following in-
structions on the display, and
then press the
{{{{OK}}}} key.
The “ Programmed ” message ap-
pears.
Hook Dial On Hook Dial
Pause/
Redial
_
ABC DEF
MNO JKL GHI
WXY TUV PRS
Clear
Modes
User Tools/
Counter
Clear/Stop
Start
AAH027S
KirC2_ENcopyF_FM.book Page 51 Monday, September 22, 2003 11:36 AM