Subaru H7110FS400 - Manual (Page 5)

5
C. Starter Interrupt Installation
1. Locate the starter interrupt 6-pin (white housing)
connector, which is located next to the right side of
the fuse box. See Figure 1.
2. Detach the jumper connector from the fixing tape,
disconnect it from the connector and discard. Then
insert the starter interrupt relay into the connector.
3. Install the relay bracket onto the stud with the M6
nut indicated by the arrow in Figure 2. The stud is
located behind the fuse box.
NOTE: When installing the starter interrupt
relay, take care not to touch the harness-
es in the vicinity of the stud by slightly
rotating the bracket.
Figure 1
Figure 2
Wire tie
Figure 10
12. As shown in Figure 10, insert the female connector
of the extension harness into the security module 18-
pin (white housing) connector.
Push the extension harness into under the center con-
sole. Take care not to damage the extension harness.
13. Make sure that the harness is not being pintched or
is not touching any sharp sheet metal. Then, securely
fix the harness to the other vehicle near by harnesses
using the supplied wire tie.
Security module
harness