Sony TA-FB940R - Manual (Page 5)

Getting Started
5
Tape deck, DAT deck, or MD deck
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck
EON CONTROL
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).
Tape deck Amplifier
Amplifier Turntable
Amplifier TV or video deck
Amplifier Tuner
Speaker System Hookups
Overview
Here you learn how to connect speakers to the
amplifier. You can connect two pairs of speakers,
SPEAKERS A and B.
Note that the SPEAKERS A terminals comprise the
bottom row of the SPEAKERS terminals.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 10 mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
З
з OUTPUT
L
R
INPUT TAPE1/DAT
L
R
IN OUT
Ç L
R
PHONO
IN
SIGNAL
GND
y
Ç L
R
L
R
OUTPUT AUX
IN
Ç
EON CONTROL
IN
EON CONTROL
OUT
(+)
(–)
(+)
(–)
]
}
]
}
b
SPEAKERS A SPEAKERS B
SPEAKERS
EON CONTROL
R
B
A
L + + – –
R L + + – –
TAPE1/DAT
L
REC OUT IN
IMPEDANCE USE 4–16 Ω A+B USE 8–16 Ω BI WIRE USE 4–16 Ω
IN
R
L
R
TAPE2/MD REC OUT IN AUX IN SACD/ CD
IN TUNER IN
L
R
PHONO
IN SIGNAL GND y