Sanus Systems NFCD - Manual (Page 2)

Supplied Hardware: (Full Size)
Step 1 - Attach Feet to NFCD Base
Insert a Machine Screw ( K) into each Foot (C); then using the regular screwdriver, attach the Feet to the NFCD Base (B).
Diagram 1
Cam - H
Qty. 4
Cam Pin - I
Qty. 4
Plastic Dowel - J
Qty. 4
Wood Screw - L
Qty. 4
Machine Screw - K
Qty. 4
Shelf Pin - M
Qty. 56
B
K
C
C
C
C
K
K
K
Step 2 - Insert Cam Pins into Side Panels
There are two holes that are centered on each side of the Side Panels ( E), and 12” [304.3 mm] from each end. Using
the phillips screwdriver, screw Cam Pins ( I) into the two holes of each Side Panel taking care not to over tighten the Cam
Pins.
Diagram 2
E
I
E