Sony FM/AM Compact Disc Compact Player D-T405 - Manual (Page 4)

D-T405.3-860-096-2X.E.U/CA2/E33/E92/AU
Presetting radio stations
You can store radio stations into the
Discman’s memory. You can preset up to 30
stations, 5 for each band (FM1, FM2, FM3,
FM4, FM5 and AM) in any order. Once you’ve
preset the stations, press one of the
1 - 5 buttons to tune in your favorite stations.
1
Tune in the station you want.
2
Hold down one of the 1 - 5 buttons that
you want to preset the new station on for
more than 2 seconds.
When the station is preset successfully,
the beep sounds and the indications
“PRESET” and M appear in the display.
The new station replaces the old one.
FM:
AM:
Playing preset radio stations
1 Press BAND (BAND on the remote control)
to select the band.
2 Press the number button (PRESET +/– on
the remote control) to tune in a stored
station.
To change the AM tuning
interval
When using the Discman abroad, change the
AM tuning interval, if necessary. Slide the
STEP switch (inside the lid) to “9 kHz” or
“10 kHz” using a pointed material.
9 kHz area: Asia and Europe
10 KHz area: the U.S.A., Canada and South
America
Notes
• The interval will not change until you once turn
off the radio and then turn it on again.
• After changing the tuning interval, you need to
preset radio stations again.
Playing a CD in a car
You can use your Discman in a car as
illustrated below.
To connect your Discman to a car cassette
deck, you need the following accessories:
• Car connecting pack CPA-9
• Car battery cord DCC-E245
or,
• Mount kit CPM-300PC (Mount plate + Car
connecting pack + Car battery cord)
or,
• Car battery cord with car connecting pack
DCC-E26CP
Refer to the instruction manual of each
accessory for details.
When you use the CPM-300PC
mount kit/CPM-300P mount plate
Attach the car mount adaptor supplied to the
CPM-300PC/300P before installing the
Discman.
Notes
• Do not put the Discman on the dashboard.
• Do not leave the Discman in a car parked
under sunlight.
• Use a Sony car connecting pack for reducing
noise.
Switched ignition function
With this feature, your Discman stops
automatically when you turn off the engine
of the car. (This function is not possible with
some cars depending on the model).
Using the remote control
For the customers supplied with the
remote control
You can use the remote control as the wired
remote control.
* Automatic Music Sensor
**When you are not using the remote control,
slide HOLD in the direction of the arrow.
To unlock, slide HOLD back.
Note
• Use only the supplied remote control. You
cannot operate this unit with the remote
control supplied with other models.
BAND
TUNING +/–
VOLUME
1 - 5
BAND
(rear)
z Power Sources
Using rechargeable
battery
Charge the rechargeable battery before using it
for the first time.
You can use either BP-DM10 or BP-DM20
rechargeable battery for this unit. You can use
them in the same way, but their charging time
and battery life are different. Check the model
number of your rechargeable battery, and use
it.
1
Set the CD/RADIO switch to “CD
(RADIO OFF).”
2
Open the lid of the battery compartment.
3
Insert the rechargeable battery so that the
word “SONY” is facing the same
direction as illustrated inside the lid, and
close the lid.
4
Connect the AC power adaptor.
The indications “CHG” and
light
up. Charge for about 2 hours (for BP-
DM10) or 3 hours (for BP-DM20).
5
When fully charged, “CHG“ and
disappear. Disconnect the AC power
adaptor.
When to charge the battery
When the battery becomes weak,
indication appears in the display. If the
battery is used up, “
Lo batt” appears in
the display. Charge the rechargeable battery.
To keep the original battery capacity for a
long time, recharge the battery when the
battery is used up (discharged).
Notes
• Charging time varies depending on how the
rechargeable battery is used.
• If the battery is new or has not been used for a
long time, it may not be charged completely
until you charge and discharge it several times.
• If the battery life becomes shorter by about half,
replace it with Sony BP-DM10 or BP-DM20
rechargeable battery. Do not use any other
rechargeable battery (R6 type rechargeable
battery, etc.).
Earphones
Remote control
HOLD**
( (play) /
=•+
(AMS*/search)/
PRESET+/–
p (stop)/
BAND
VOL (volume)
BAND
1 - 5
to a wall outlet
AC power adaptor
DC IN 4.5 V
z Radio operations
Listening to the radio
1
Set the CD/RADIO switch to “RADIO.”
2
Press BAND until the band you want
appears.
Each time you press the button, the
display changes: FM1 n FM2 n FM3 n
FM4 n FM5 n AM.
3
Press TUNING +/– to tune in the station
you want and adjust the volume.
To turn off the radio
Set the CD/RADIO switch to “CD (RADIO
OFF).”
Notes
• When you do not listen to the radio, set the
CD/RADIO switch to “CD (RADIO OFF)” to
save the battery power.
• You cannot turn on/off the radio nor tune in
the station using the remote control.
Use the remote control when listening to the
preset radio stations.
To tune in the station quickly
Hold down TUNING +/– in step 3 until the
frequency digits begin to change in the
display. The Discman automatically scans the
radio frequencies and stops when it finds a
clear station.
To improve broadcast reception
For FM, extend the headphones/earphones
cord.
For AM, reorient the Discman itself.
Note
• Keep the headphones/earphones connected to
the PHONES/REMOTE jack of the player even
when listening to the FM program through the
speakers connected to the LINE OUT jack of
the player. The headphones/earphones cord
works as the FM antenna.
When listening to the radio on dry
batteries or rechargeable battery
If you connect the external power source plug
to the DC IN 4.5 V jack of your Discman, the
radio station will change to the initial one
(default). Tune in the station again to
continue listening to it.
CD/RADIO
TUNING +/–
Headphones
or
Earphones