Samsung GH68-12949A - Manual (Page 2)

Guide No.: GH68-12949A
11/2006. Rev. 1.0
Quick Start Guide
Samsung
Bluetooth ® Headset
WEP210
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP210. We hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.
Make sure you have the following items with your
headset:
Make sure you have the following items with your
headset:
Travel Adapter, User’s Guide Travel Adapter, User’s Guide
Check the accessories Check the accessories Charge your headset Charge your headset
Charge the headset's battery fully before using
the headset for the first time.
1 Plug the travel adapter into the jack on the
headset.
2 Plug the travel adapter into the electrical
outlet.
• Charge the headset until the red light on the
headset turns to blue.
• The headset will be fully charged in
approximately 2 hours and 30 minutes.
Before you can use your headset, you must pair it
with your phone.
Put your headset in
pairing mode
Turn on Bluetooth on your
phone and pair with headset
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
1 Place the headset over your ear.
See Wear the headset on the reverse
side of this guide.
2 On your phone, make a call to the number
you want.
3 If your phone and headset are successfully
paired, you will hear ringing on the headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
Test and use
Using your WEP210
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP210.
1 Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2 Press and hold the Multi-Function button until the blue
indicator light stays on after blinking.
Before using your headset
Volume Up
button
Adapter jack Microphone
Indicator light
Volume Down
button
Earpiece
3 Remove the travel adapter from the headset.
• The headset cannot be used while charging.
• Use only a Samsung-approved charger or adapter.
Start here
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Test and use
Get connected in 4 quick steps
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357
Multi-Function
button
The items supplied with your headset may vary, depending
on your country or service provider.
1 Set your Bluetooth phone to discover the
headset by following your phone's guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
Your phone will find the Samsung WEP210
headset and ask if you want to pair with it.
Confirm this by pressing the Yes or OK key.
2 Enter a passkey or PIN, 0000 (4 zeros), then
press the Yes or OK key.
• Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)
• Supported Bluetooth Profiles:
- Headset Profile
- Hands-Free Profile