Sprint Nextel MM-A800 - Manual (Page 190)

176 Section 2J: Using the Built-in Camera and Camcorder
Ⅲ
On This Shot to activate the flash for one shot.
Ⅲ
Always to activate the flash for all pictures.
Setting the Self-Timer
To activate the Self-Timer:
1. From camera mode, press Options ( ).
2. Highlight Self-Timer and press the navigation key up
or down to select the desired length of delay
(Off, 10 seconds, 5 seconds) and press .
3. Press to focus the image. (If the focus is
successful, the view finder focus points will
turn green. If unsuccessful, they will turn red.
4. Select Capture ( ) when you are ready to start the
timer.
5. Get ready for the picture. (The phone will begin to
beep when the timer is started.)
To cancel the Self-Timer after it has started:
ᮣ
Press .
Note: Auto-Focus must be turned on to press OK before taking
the picture. If Auto-Focus is turned off, pressing OK will
take the picture. To turn Auto-Focus on, see “Selecting
Camera Settings” on page 180.
Note: While the Self-Timer is active, all keys are disabled except
Back (stops the timer and returns to the camera mode), End
(cancels the timer and returns to standby mode), and the
right softkey button (Cancel).