Important safety instructions – Snapper SV25650B EN User Manual

Page 3

Advertising
background image

IMPORTANT SAFETY INSTRUCTIONS

SAFE HANDLING OF GASOLINE

(Continued From Previous Page)
3. DO NOT remove fuel cap or add fuel with the engine

running. Allow the engine to cool before refueling.

4. DO NOT refuel the machine indoors.
5. DO NOT store the machine or fuel container inside

where there is an open flame, spark or pilot light
such as on a water heater or other appliances.

6. DO NOT fill fuel containers inside a vehicle or on a

truck or trailer bed with a plastic liner. Always place
the containers on the ground away from the vehicle
before filling.

7. Remove gas-powered equipment from the vehicle or

trailer and refuel it on the ground. If this is not
possible, then refuel equipment using a portable
container, rather than a gasoline dispenser nozzle.

8. DO NOT start gas powered equipment in enclosed

vehicles or trailers.

9. Keep the nozzle in contact with the rim of the fuel

tank or container opening at all times until fueling is
complete. DO NOT use a nozzle lock-open device

10. If fuel is spilled on clothing, change clothing

immediately.

11. DO NOT overfill a fuel tank. Replace fuel cap and

tighten securely.

OPERATION

1. DO NOT put hands or feet near rotating parts. Keep

clear of intake and discharge areas while engine is
running.

2. STOP engine when crossing gravel drives.
3. Operate machine only in daylight or good artificial

light.

4. DO NOT operate machine while under the influence

of alcohol or drugs.

5. If machine vibrates abnormally, STOP the engine,

disconnect and secure spark plug wire. Inspect the
machine for any damage and repair the damage
before resuming operation.

6. DO NOT operate machine near drop offs, ditches or

embankments. Operator could lose footing or
balance.

7. STAY ALERT for holes and other hidden hazards.

Keep away from ditches, washouts, culverts, fences
and protruding objects.

8. DO NOT operate machine on wet grass. Always be

sure of your footing. Keep a firm hold on the handle
and walk, never run. Slipping could cause injury.

9. DO NOT leave the machine unattended with the

engine running.

10.

Before cleaning, repairing or inspecting make
certain engine has completely STOPPED.
Disconnect and secure spark plug wire away from
plug to prevent accidental starting.

11. DO NOT start or operate machine with debris bag

zipper open.


OPERATION

(Continued From Previous Column)
12.

Engine must be completely STOPPED before
removing debris bag.

13. DO NOT operate machine without the entire debris

bag and guards in place.

14. Slow down before turning.
15.

Watch out for traffic when near or crossing
roadways.

16. DO NOT operate engine in enclosed areas. Engine

exhaust gases contain carbon monoxide, a deadly
poison.

17. If vacuum inlet or discharge becomes plugged,

STOP engine. Disconnect sparkplug wire and
secure away from sparkplug. Use a stick to clear the
plug when possible. If hands must be used to
remove plug, always wear heavy gloves as the
debris may be sharp.

MAINTENANCE AND STORAGE

1. DO NOT store machine or fuel container inside

where fumes may reach an open flame, spark or
pilot light such as in a water heater, furnace, clothes
dryer or other gas appliance. Allow engine to cool
before storing machine in an enclosure. Store fuel
container out of reach of children in a well
ventilated, unoccupied building.

2. Keep machine and engine free of grass, leaves or

excess grease to reduce fire hazard and engine
overheating.

3. When draining fuel tank, drain fuel into an approved

container outdoors and away from open flame.

4.

Keep all bolts, nuts and screws properly tight.

Check that all cotter pins are in proper position.

5. Always provide adequate ventilation when running

engine. Engine exhaust gases contain carbon
monoxide, a deadly poison.

6. Service engine and make adjustments only when

engine is stopped. Removed spark plug wire from
spark plug and secure wire away from spark plug to
prevent accidental starting.

7. DO NOT change engine governor speed settings or

overspeed engine.

8. Check debris bag assembly frequently for wear or

deterioration to avoid thrown objects and exposure
to moving parts. Replace with new bag if loose
seams or tears are evident. Replace bag adapter if
worn, broken or cracked.

9. DO NOT test for spark by grounding spark plug next

to spark plug hole; spark plug could ignite gas
exiting engine.

10. Have machine serviced by an authorized dealer at

least once a year and have the dealer install any new
safety devices.

11.

Use only genuine replacement parts purchased

from your authorized dealer to assure that original
standards are maintained.

Advertising