Sony CPD-E500E - Manual (Page 6)

6
Setup
Before using your monitor, check that the following accessories
are included in your carton:
• Power cord (1)
• HD15 video signal cable (1)
• Macintosh G3 adapter (for blue and white system) (1)
• Setup Disk (1)
• Warranty card (1)
• Notes on cleaning the screen’s surface (1)
• This instruction manual (1)
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• When connecting the video signal cable, check the alignment of the
HD15 connector. Do not force the connector in the wrong way or the
pins might bend.
x x x x Connecting to an IBM PC/AT or compatible
computer
x x x x Connecting to a Macintosh computer
* Connect the supplied Macintosh G3 adapter to the computer before
connecting the cable. This adapter is compatible with the Power
Macintosh G3 computer that has three rows of pins. If you are
connecting to the other version of Power Macintosh G3 series computer
with two rows of pins or other models, you will need a different adapter
(sold separately).
Step 2: Connect the power cord
With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
(HD15)
AC IN
HD15 video signal
cable (supplied)
to video output
IBM PC/AT or compatible
computer
to HD15
(HD15)
AC IN
Use the supplied Macintosh G3 adapter (for blue and white
system).
to HD15
Macintosh G3 adapter
(for blue and white
system) (supplied)
*
Power Macintosh G3
to video
output
HD15 video signal
cable (supplied)
(HD15)
AC IN
to AC IN
to a power outlet
power cord (supplied)