Snap-On 870011 - Manual (Page 6)

OPERATION IN SINGLE SEQUENTIAL ACTUATION MODE
To select the Single Sequential Actuation Mode (see
Figure 1):
1. Press and hold the red Actuation Selector embedded
in the trigger.
2. Rotate Actuation Selector down to the Single
Sequential Actuation (T).
3. Release Actuation Selector, ensuring locking tab is
fully seated in the slot.
Ensure selector has locked into position. Ensure
actuation process is fully understood before attempting to use clipped head
nailer.
TO USE THE CLIPPED HEAD NAILER IN SINGLE SEQUENTIAL
ACTUATION MODE:
1. Firmly grip clipped head nailer handle.
2. Position clipped head nailer work piece
contact on work piece surface.
3. Push clipped head nailer against work
piece compressing work piece contact.
4. Pull trigger on clipped head nailer to
drive nail. The clipped head nailer will
recoil away from the work piece as nail
is driven.
5. Remove finger from trigger and lift
clipped head nailer away from surface
of work piece.
OPERATION IN CONTACT ACTUATION MODE
When using contact actuation mode, be careful of unin-
tentional double fires resulting from tool recoil. Unwanted fasteners may be
driven if the work piece contact is allowed to accidentally re-contact the work
piece.
9 10
To improve the connection between the quick disconnect and air nailer, and to help
prevent oxidation, apply PTFE tape or joint compound to the connector threads
before insertion.
3. Snap the air hose onto the quick disconnect on the air nailer. Check for air
leaks.
LUBRICATION
To ensure maximum performance, it is recommended to install an air set (oiler, reg-
ulator, and air filter) as close as possible to the air nailer. Adjust the oiler so that
approximately one drop of oil will be released for every 50 nails.
If an air set is not used or is unavailable, oil the tool using pneumatic tool oil by plac-
ing 2 or 3 drops into the air inlet. This should be done before and after use. For
proper lubrication, the tool must be fired several times after the oil is introduced to
the filter.
OPERATING THE CLIPPED HEAD NAILER
Always use hearing protection to protect your ears against
hearing loss due to exhaust noise. Always wear proper safe-
ty glasses to prevent injuries to the eyes from fragments of
the work piece, defective nails or other debris caused by using the clipped
head nailer. All safety glasses must have side shields and should conform to
the requirements of the American National Standards Institute (ANSI) z87.1.
Failure to comply with this warning could lead to serious or permanent damage
to the ears as well as serious damage or permanent blindness in the eyes.
Always disconnect the air hose before making adjustments or checking the
functionality of the air nailer.
SELECT TRIGGER ACTUATION MODE
The clipped head nailer is equipped with a selectable trigger. This allows the selec-
tion of Single Sequential Actuation Mode or Contact Actuation Mode.
Figure 1