Samsung GH68-11254A - Manual

Guide No.: GH68-11254A
0
9/2006. Rev. 1.2
1
Set your Bluetooth phone to discover the
headset by following your phone's guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
Your phone will find the Samsung WEP200
headset.
2
Select Samsung WEP200.
3
When the phone asks if you want to pair with it,
confirm by selecting Yes or OK.
4
Enter the headset passkey or PIN, 0000.
Quick Start Guide
Bluetooth Mono Headset
WEP200
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP200, we hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset. Make sure you have the following items with your
headset: Make sure you have the following items with your
headset:
Charging case, Travel adapter, Manual,
2 headset hooks Charging case, Travel adapter, Manual,
2 headset hooks
Charging case, Manual, 2 headset hooks
For Set 2, use your phone charger as a
power source for recharging. Charging case, Manual, 2 headset hooks
For Set 2, use your phone charger as a
power source for recharging.
Check the accessories Check the accessories Charge your headset Charge your headset
Charge the headset's battery fully before using
the headset for the first time.
1
Put the headset in the supplied charging case
and close the cover.
2
Plug the travel adapter into the case's
charging socket.
3 Plug the travel adapter into the electrical
outlet.
4
Remove the travel adapter from the case.
• For Set 1, use the travel adapter provided.
• Charge the headset until the red light on the
headset turns to blue.
• The headset will be fully charged in
approximately 2 hours.
Before you can use your headset, you must pair it
with your phone.
The indicator light flashes in blue as you press and
hold the Multi-Function button. Continue holding
down the button until the blue light is steadily lit.
Put your headset in
pairing mode Turn on Bluetooth on your
phone and pair with headset
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
1
Place the headset over your ear.
See Wearing the headset on the reverse
side of this guide.
2
On your phone, make a call to the number
you want.
3
If your phone and headset are successfully
paired, you will hear ringing on the headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
Test and use
Using your WEP200
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP200.
1
Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2
Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).
Before using your headset
Multi-Function button
Hook
Volume control
buttons
Indicator light
Microphone
Charging contact
NOTE:
The headset cannot be used while charging.
NOTE:
Your headset supports the headset and/or hands-free
profile(s).
Set 1:
Set 2:
Start here
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Test and use
Get connected in 4 quick steps
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357