Sportline Heart RAte Monitor & Pedometer 965 - Manual (Page 13)

24 25
965 HEART RATE MONITOR + PEDOMETER
POTENTIAL CAUSES FOR NO HEART RATE READING OR LONG
RESPONSE TIME:
CAUSE: Dry Skin
SOLUTION: Apply conductive gel thoroughly to fi nger. Tap water
may help if conductive gel is not available.
CAUSE: Muscle tremors caused by pressing on Sensors too hard
SOLUTION: Decrease fi nger pressure on the Sensor Pads.
CAUSE: Dead skin on wrist or fi nger
SOLUTION: Rub off excessive dead skin with a towel.
CAUSE: A thin layer of body grease insulates the ECG signal
preventing the Watch from detecting ECG heart rate.
SOLUTION: Wipe wrist and the back of watch with a tissue or soft
towel.
CAUSE: Hairy Skin
SOLUTION: Apply conductive gel to wrist.
CAUSE : Low Battery
SOLUTION: Replace the battery in watch.
FCC COMPLIANCE TROUBLE SHOOTING
www.sportline.com
The device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Changes or modifi cations not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the product.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the transmitting
equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio technician for
help.
SP1036IS01SPO.indd 24-25 SP1036IS01SPO.indd 24-25 7/10/12 6:19 PM 7/10/12 6:19 PM