SSS SIEDLE BSE 650-0 - Manual (Page 8)

7
Switch off the programming
mode at the BSG 650-...
The status LED goes out, operating
status of the overall system.
Fig. 6
Defining the bell buttons for
actuation of the BSE 650-...
Important!
The BTLM 650-... or BTLE 051-... is
active.
Programming the BSE 650-... is only
possible if the YR system is active.
Switch the BSG 650-... to the
programming mode;
The status LED flashes evenly.
Fig. 2
BTLM 650-... or BTLE 051-... acti-
vated
Fig. 13
Switch the BSE 650-... you wish
to program to the programming
mode;
The status LED flashes very slowly.
Fig. 14
At the door loudspeaker, press
the call button which you wish
to actuate the BSE 650-... ;
Fig. 15
Switch off the programming
mode at the BSG 650-... ;
The status LED goes out, operating
status of the overall system.
Fig. 6
or
process other programming points
such as defining the switching time /
switching function of the relay con-
tact.
Deleting the bell buttons for
actuation of the BSE 650-...
Switch the BSG 650-... to the
programming mode;
The status LED flashes evenly.
Fig. 2
BTLM 650-... or BTLE 051-... acti-
vated
Fig. 13
At the door loudspeaker, press
the call button you wish to dele-
te
Fig. 15
Switch off the programming
mode at the BSG 650-... ;
The status LED goes out, operating
status of the overall system.
Fig. 6
or
process other programming points
Defining the switching time /
switching function of the relay
contact
Important!
If you pause for periods longer than
5 seconds, i.e. if the button at the
BSE is not actuated for this period,
the BSE 650-... automatically swit-
ches out of the programming mode.
The relay can be programmed for
the switching function in two diffe-
rent ways.
Toggle mode
On/off function every time the but-
ton is actuated
(as-delivered status).
or
Time relay
When actuating the button, the
relay switches for the programmed
time (retriggering possible).
Toggle function
Switch the BSG 650-... to the
programming mode;
(if not already switched on)
The status LED flashes evenly.
Fig. 2
Switch the BSE 650-... you wish
to program to the programming
mode;
The status LED flashes very slowly.
Fig. 3
Switch the BSE 650-... to the
time setting mode;
The status LED flashes unevenly 3:1
Fig. 9
Set the toggle switching func-
tion at the BSE 650-... ,
save and at the same time switch
off the programming mode.
The status LED goes out
Fig. 10
Switch off the programming
mode at the BSG 650-...
The status LED goes out,
operating status of the overall
system.
Fig. 6
or
Time relay function
Switch the BSG 650-... to the
programming mode;
(if not yet switched on)
The status LED flashes evenly.
Fig. 2
Switch the BSE 650-.. you wish
to program to the programming
mode;
The status LED flashes very slowly.
Fig. 3
Switch the BSE 650-... to the
time setting mode;
The status LED flashes unevenly 3:1
Fig. 9
Set the time relay switching
function at the BSE 650-... ;
The status LED flashes quickly
Fig. 11
In the „time relay switching func-
tion“ mode, a programming time
limitation of 5 seconds is integrated.
If the button is not actuated at the
BSE within this time, the BSE 650-...
switches automatically out of the