StarDot Technologies net camera - Manual (Page 15)

NetCam Page 15
Haze
Haze is a factory setting and should normally not be changed.
Default: 10
JPEG Quality
The JPEG Quality is a balance between lossy image compression
and image quality. The higher the number, the less compression artifacts
in the image, but the bigger the file size. A value higher than 90 is not
recommended, as it greatly increases the file size with very little
noticeable difference in image quality.
Default: 70
Sharpen
When enabled, a software sharpening is performed on the live image.
For the best image quality, sharpen should be on.
Default: On
Auto Color Balance
Enabling Auto Color Balance causes NetCam to automatically adjust
the color balance of the image, based on the content of the image. In most
situations, you will want Auto Color Balance enabled. You can skew the
red, green and blue values if needed.
Default: On
Manual Color Balance
Enabling Manual Color Balance causes NetCam to use the manual Red,
Green and Blue values to set the color balance of the image. You may want
use manual color balance if you have a fixed lighting situation.
R - This represents the amount of red in the image.
G - This represents the amount of green in the image.
B - This represents the amount of blue in the image.
Note: As a starting point for setting manual color balance values,
enable Auto Color Balance and place the current R, G, B values in the
image overlay.
Sample string: Red: $r Green: $g Blue: $b
Once you see the current values of the image, you can place those in the R,
G, B settings and have a manually balanced image.