Stanton SMX.211 - Manual (Page 4)

MIXER FEATURES
1. Input fader - Controls individual source levels (channels) in the mix.
2. Input toggle switch - Selects which source will be active based on what you have connected to the
rear panel input section (phono/line).
3. Treble and Bass EQ - Adjusts the high and low frequency levels of the input channels for good
sound.
4. Channel Gain - Adjusts the pre-fader volume for cleaner sound.
5. Replaceable Crossfader - Achieves clean fades between the two input channels. "Hard left"
selects Channel 1. "Hard right" selects Channel 2. With the crossfader centered, both assigned
channels are live. Use the crossfader for fast and seamless (fades) from one selected
channel to the other.
Note: The crossfader is user replaceable in case of failure. Simply unscrew the two large screws
which hold it in place, lift it out and disconnect it ís cable. Re-attach the new crossfader and screw
the mounting plate back onto the unit - you' re back in business!
6. Mic Input Gain - Adjusts microphone input level.
7. Mic Input - Insert your Microphone with 1/4 plug in here.
8. Headphone Input - Insert in the
1/4 plug for your headphones here.
9. Channel Cue / Cue Pan - Used to preview channel audio to your headphones. Listen here before
bringing up channel faders or moving the crossfader.
10. Headphone Level - Adjusts cue volume.
11. Master Fader - Controls the overall output level.
REAR PANEL
12. Grounding post - for turntable connection.
Always use this connection when using
standard turntables with ground cable.
(Some turntables like the STR8-80 /100
do not require grounding wire).
13. Phono Inputs - Plug your turntables in
here. When these connectors are used,
your signal is fed directly to the high-
quality RIAA phono pre-amplifiers. Use
this position only for turntables. Line level
sources will overload the sensitive phono
pre-amps and will cause distortion.
14. Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD
players, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, laser discs, tuners, even
synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector.
15. Stereo Main Outputs - Unbalanced RCA connectors controlled by the Master fader.
16. Fader Start - This function works in conjunction with a compatible fader start CD player. When
used with a compatible CD player, you can use the crossfader to start and stop the CD player with
the slide of the fader. The fader start switch activates the fader start feature. When in the ON
position, the fader start allows the fader to return automatically to preset digital CUE POINTS on
your compatible STANTON DJ CD Player.
17. Power Connector - Plug in power adapter here and check the voltage level to match your country ís
standard.
18. Power Switch - turns unit off and on. Note*** Remember to turn ALL volume levels down when
turning on/off the unit.
18 17 15 14 13 12 16