Sunbeam HS9500 - Manual (Page 8)

Using your Styler
6
Ceramic Heater
Your hairstyler has a ceramic heater. This can be
seen working by the high intensity red indicator
light. The light comes on to show it is working and
remains static for a few seconds. It then flashes
rapidly and when the maximum temperature is
reached the light will slow to a steady flash.
If the styler is being used on a high heat setting
and you switch to a lower setting, the light will go
out until the plate temperature reduces. It will then
work as normal.
• Before you start to style your hair, comb through
so that there are no tangles.
• For best results, hair must be completely dry.
• Plug in to a suitable supply and switch the unit
on. The neon light will come on.
• There is no need to pre heat the styler. The styler
will get very hot very quickly so do not touch the
plates with your fingers.
• Use the variable heat control to adjust the heat
to suit your hair type. Turn the dial clockwise to
increase the heat and anticlockwise to decrease.
Use a lower heat on young or fine hair and a
higher temperature on thick or curly hair.
• The maximum temperature reached is 200
degrees and the minimum is 150 degrees.
• Apply a styling lotion. We recommend PPS
professional products.
• Beginning at the back, use clips to section the
hair. Take a section approximately 5cms wide
and comb or brush it through. Working from root
to the ends, place the section between the plates
and squeeze the handle shut. Be careful not to
touch your skin.
• Hold the styler in place for 3 to 5 seconds
depending on your hair type (3 seconds for fine
hair and up to 5 seconds for thicker hair).