Sony CAROUSEL R-1405 - Manual (Page 27)

7
O T H E R C O N v E N I E N T F E A T U R E S
LIGHT
Press the LIGHT pad one time to turn it on and once
again to turn it off.
FAN
The fan will automatically start when heat rises from
range surface units or burners. This protects the micro-
wave oven from excessive temperature rise. The fan
will stay on until the temperature decreases. It cannot
be turned off manually during this time.
Press
FAN pad one time to turn it on and once again
to turn it off.
If you wish to have the oven operate with no audible
signals, touch
TIMER/CLOCK, the number 5 and then
touch START pad and hold for three seconds.
To cancel and restore the audible signal, touch TIMER/
CLOCK, the number 5 and STOP/CLEAR pads.
AUDIbLE SIGNAL
ELIMINATION
To demonstrate, touch TIMER/CLOCK, the number
0 and then touch the START pad and hold for three
seconds. DEMO will appear in the display. Cooking
operations and specific special features can now be
demonstrated with no power in the oven. For example,
touch
MINUTE PLUS pad and the display will show
1:00 and count down quickly to End .
To cancel, touch TIMER/CLOCK, the number 0 and
STOP/CLEAR pads. If easier, unplug the oven from the
electrical outlet and replug.
DEMONSTRATION MODE
R E P L A C I N G P A R T S
LIGHT
1. To replace light bulbs, first disconnect power to the
oven at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light cover.
(See illustration.)
3. Replace light bulbs with equivalent watt bulb
available from your Sharp Authorized Servicer or
parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE
A BULB LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed in
step 2.
CAUTION: Light cover may become very hot. Do not
touch glass when light is on.
CHARCOAL FILTER
Charcoal Filter, Sharp part number RK-250 is used for
nonvented, recirculated installation. The filter should be
changed every 6 to 12 months depending on use. See
page 14 for ordering information.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove the three louver mounting screws and
push down carefully on the tab at each end of the
louver to disengage it. (See illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place (engag-
ing both the bottom and top tabs) and replace the
screws removed in step 2.
Light
cover Screw Light
bulbs
Louver
Top tab
Bottom tab
Screw
Screw
Screw
Charcoal filter
(white side faces front)
318-3_1405,06 manual.indd 27 5/14/07 2:14:05 PM