Sharper Image SR277 - Manual (Page 8)

1. To switch on the speakers, press the ON/OFF button located on the front
panel of each speaker. A blue power LED illuminates. Power may also be
switched on from the remote control.
Note: The ON/OFF button on the remote control does not function as the primary
power switch for the speakers. To operate the ON/OFF function by remote con-
trol, speaker power must be switched ON first. (See Power Off.)
2. To listen to a desired audio source through the speakers, switch on the audio
device that the transmitter base is connected to. The blue LED on the transmit-
ter illuminates.
3. Depending on location, select CHANNEL 1 or 2 on the transmitter base for
optimal performance.
4. For optimal reception, ensure the transmitter and speaker receivers are
approximately 21 feet apart.
5. To locate the strongest operating frequency, press the AUTO TUNE button
located on the front speaker panel. When the Auto Tune function is engaged,
frequency scanning begins automatically and stops when a signal is detected.
The Auto Tune function may also be activated from the remote control.
6. You should experience interference-free speaker reception during normal
room to room or outdoor operation. If interference or poor signal reception
occurs, press the AUTO TUNE button located on each speaker once (the blue
LED indicator illuminates) to locate the strongest operating frequency.
7. If peak reception remains elusive, switch the CHANNEL setting (1 or 2) on the
transmitter base, then press the AUTO TUNE button on the speakers to locate
the corresponding frequency.
8. Use the BASS BOOST function to add a fuller bass sound to any audio program.
• To switch BASS BOOST on, press the BASS BOOST button.
• To switch BASS BOOST off, press the BASS BOOST button again.
Speaker Operation
8