Stamina Products 55-1615 - Manual (Page 7)

ASSEMBLY INSTRUCTIONS
7
Place the front end of the RIGHT PEDAL ARM(5) on the ROLLER(40). Connect the back end of the RIGHT
PEDAL ARM(5) to the RIGHT CRANK(32) located inside the CRANK DISK(29) as shown. Thread the
RIGHT PEDAL SHAFT(35) into the RIGHT CRANK(32) and tighten securely. Repeat on the left side.
STEP 4
There is a "L" decal on the LEFT PEDAL CAP(38), and a "R" decal on the RIGHT PEDAL CAP(39).
Attach the RIGHT PEDAL CAP(39) onto the RIGHT PEDAL ARM(5) with ROUND HEAD BOLTS
(M6x1x43mm)(53). Repeat on the left side.
NOTE:
There is a "L" decal on the LEFT PEDAL ARM(4), and a "R" decal on the RIGHT PEDAL
ARM(5).
The RIGHT PEDAL SHAFT(35) has right hand threads and is tightened by turning clockwise.
The LEFT PEDAL SHAFT(34) has left hand threads and is tightened by turning counter clockwise.
STEP 3
NOTE:
The LEFT and RIGHT PEDAL CAPS(38, 39) have a raised lip on two sides. Attach the LEFT and
RIGHT PEDAL CAPS(38, 39) to the LEFT and RIGHT PEDAL ARMS(4, 5) so the raised lip is on
the front and the inner side.
1.
2.
R
L
R
L