Stamina Products 15-0200 - Manual (Page 12)

STORAGE
To store the INTONE Folding Recumbent Bike simply keep it in a clean dry place.
The minimum folded dimensions of INTONE Folding Recumbent Bike are approximately 21 5/8" long
x 25 3/8" wide x 42 1/4" tall. Please measure your INTONE Folding Recumbent Bike if exact dimensions
are needed.
The INTONE Folding Recumbent Bike has a pair of MOVING WHEELS(48) built into the FRONT
STABILIZER(4) at the front. Grasp the HANDRAIL(7), tip the INTONE Folding Recumbent Bike
forward slowly roll into or out of the storage area.
To avoid damage to the METER(32), remove the batteries before storing the INTONE Folding
Recumbent Bike for one year or more.
Follow the illustrated process below to fold the INTONE Folding Recumbent Bike. 1.
2.
3.
4.
5.
Loosen the LOCKING KNOB(45). Lift up the BACK SUPPORT(6) and fold it forward. Tighten the
LOCKING KNOB(45) after folding.
Remove the PULL PIN(47) from the REAR FRAME(2). Fold the REAR FRAME(2) close to the MAIN
FRAME(1) and lock it in folded position with the PULL PIN(47).
NOTE:
B
12
D
A
C
Loosen and pull the ADJUSTMENT KNOB(41), then lower the SEAT FRAME(5) to the lowest position.
Lock the SEAT FRAME(5) in position by releasing and re-tightening the ADJUSTMENT KNOB(41).
Swing the METER(32) down toward the floor as ahown in illustration D.
a.
b.
Make sure the LOCKING PIN(47) go through the holes at both sides of the REAR FRAME(2)
and the ring on the MAIN FRAME(1).
NOTE:
c.
If you unfold the INTONE Folding Recumbent Bike from the folded position as shown illustration
C, the seat hight and the angle of the METER(32) will remain as you have them adjusted for your
workout. You can fold your INTONE Folding Recumbent Bike even smaller by following Step
C; however you seat height and meter angle will need to be re-adjusted before your next workout.