Sony ZS-D55 - Manual (Page 38)

Additional Information 38 GB
Troubleshooting (continued)
Remedy
• Press MODE until “STEREO” appears.
• Depending on the FM reception conditions,
noise may be heard.
• Replace all the batteries with new ones if they
are weak.
• Move the player away from the TV.
• If you are using the remote while listening to
MW/LW radio, noise may be heard. This is
unavoidable.
• If you are listening to an FM programme near
the TV with an indoor aerial, move the player
away from the TV.
• Insert the tape properly and close the tape
compartment securely.
• Replace all the batteries with new ones.
• Make sure the safety tab of the tape in the tape
compartment is in place.
• Press x on the TAPE section to switch the
function of the player to “TAPE”.
• Clean the erasing heads (see page 40).
• The source which was recorded on TYPE II
(high position) or TYPE IV (metal) tape using
this unit is being played. Record on TYPE I
(normal) tape and play.
• Make sure the tape is inserted properly.
• Make sure the safety tab of the tape in the tape
compartment is in place.
• Clean the heads, pinch rollers and capstans (See
page 40).
• Demagnetize the heads using a demagnetizer
(see page 40).
• Replace all the batteries with new ones if they
are weak.
• The tape player can be paused during recording
only.
Tape Player
Symptom
The audio is not stereo.
The audio is weak or has poor
quality.
The picture of your TV becomes
unstable.
The tape does not move when you
press an operation button.
The z/X button does not
function/The tape does not play.
The tape does not erase completely.
The tape does not record.
The audio is weak/The audio
quality is poor.
The tape player cannot be paused
during playback.
Radio