Silvercrest SZP25A1-07 - Manual (Page 6)

- 4 -
Juice extraction
Note:
When pressing out juice, do not exceed the 600 ml
volume marking on the scale of the juice collector
u .
1. Adjust the fruit pulp regulator t , by sliding it, so
that the slits in the fruit pulp sieve r / y lie
exactly above each other if you wish to have fru-
it juice with fruit pulp. Adjust the fruit pulp regula-
tor
t , by sliding it, so that the slits in the fruit
pulp sieve r / y are not lying above each other
if you do not wish to have fruit juice with fruit
pulp.
2. Cut the fruits in half (orange, lemon etc.)
3. Press the halved fruit lightly onto the squeezing
cone w / e . The appliance switches itself on
automatically as soon as the squeezing cone
w / e is pressed down.
4. Apply pressure at various parts of the fruit rind
with your fingers. Thereby the juice will be even-
ly squeezed out of the fruit.
5. When no more juice flows from the fruit, stop
applying pressure to the squeezing cone w / e .
The appliance stops.
6. Press the squeezing cone w / e down repeated-
ly to loosen it, until it turns in the opposite
direction.
7. When no more juice flows from the fruit, stop
applying pressure to the squeezing cone w / e .
The appliance stops. Remove the fruit skin from
the squeezing cone
w / e .
8. Continue similarly with further fruit-halves until
you have squeezed out the desired volume of
fruit juice. The current volume squeezed can be
read off from the scale on the side of the juice
collector
u .
Emptying
Important:
Remove the power plug from the wall socket when
you empty the fruit pulp sieve
r / y or the juice
collector u . Otherwise there is a risk that the appli-
ance could start unintentionally.
• Turn the juice collector u anti-clock-wise until the
perceptible resistance desists. You can now lift it
from the drive axle
i and pour the juice out.
Disassembly
If you wish to disassemble the Citrus Press, e.g. for
the cleaning of it, proceed as follows:
1. Remove the power plug from the wall socket
o .
2. Remove the squeezing cone w / e .
3. Remove the fruit pulp sieve r / y .
Press the hook on the underside of the upper fruit
pulp sieve
r inwards. At the same time exert
light pressure on the fruit pulp sieve t . The com-
ponents allow themselves to be pressed apart.
4. Turn the juice catchment container u anti-
clockwise until the perceptible resistance
diminishes. You can now lift it from the drive
axle
i .
IB_56611_SZP25A1_LB6 30.07.2010 11:17 Uhr Seite 4