Siemens GSM 900 - Manual (Page 92)

31.5.02 06-S46 Body.fm i 37 Eagle Am Engl, A31008-H4500-A1-4-7619
87
Fax/Data Mode Using a PC ©
§Menu§ Setup
Connectivity
Fax/data mod.
Faxes and data may be transmitted
and received when the phone is
connected to a PC. In order to do
this, the phone must be connected
via infrared or a data cable to a PC
installed with data/fax
communication software (available
from a third party source).
Fax and data services must be
enabled by the service provider.
Different networks support different
types of fax/data reception. Contact
your service provider for details.
Fax/data mode
Your service provider must provide
you with a number for your
telephone and a separate fax/data
number.
Sending
Start your PC communication
software program and enter the
required destination phone number.
Receiving
When a fax or data is being received,
the call is signaled by a special ring
and the type of call (either fax or
data) will be displayed.
Start the communication software
program in your PC to receive the
fax/data
Z
Voice/fax
Sending
§Menu§ Setup
Connectivity
Fax/data mode
Send vce/fax
Set this function on the phone before
transmission so that you can switch
from voice mode to fax mode.
While the connection is being
set up, the following soft key is
briefly available:
§Voice/fx§ Switch to Send vce/fax
mode; you may now
send a fax.
Receiving
(Only if a special fax or data number
is not available).
Start the required communication
program in your PC and switch on
the function at the phone
during the
call (the PC accepts the connection).
§Menu§ Setup Connectivity
Fax/data mode
Voice/fax rec
End transmission
End transmission in the PC software
and/or press
-
.