Sanus Systems VISION MOUNT VMPO - Manual (Page 6)

Step 7: Attach Flat Panel LCD directly to VMPO
To figure out the hardware needed to attach the VMPO directly to the TV, start by determining the diameter of the Bolt (M4 or M6) your
TV requires by hand threading them into the threaded insert on the back of the TV. If you encounter any resistance stop immediately!
Once you have determined the correct diameter, see the appropriate Diagram below. You will thread the Bolt through the appropriate
Lock Washer (t,u), the Top Assembly (m), and finally thread it into the TV. Proceed to tighten all 4 Bolts until tight with a phillips screw
driver.
Note: Instances where there is an obstruction near the threaded insert in the back of the TV will require the use of a Spacer (v,w)
and the longer Bolt (q,s). For those instances see the M4 x 30 or M6 x 35 Diagram.
M4 x 10 Diagram
m
t M4 x 30 Diagram
p
v
m
t
q
M6 x 12 Diagram
m
u r M6 x 35 Diagram
u
s
w
m