Hardware installation, Software installation – SIIG ZR User Manual
Page 3
3
Hardware Installation
General instructions for installing the card are provided
below, since the design of portable computers may vary.
Refer to your system’s reference manual for further
information, if needed.
1.
Power off your portable computer and any other
connected peripheral devices.
2.
Insert the PC Card into the CardBus Type II slot of
your PC with its 68-pin connector facing the slot.
Make sure it is inserted all the way in for a solid
connection.
3.
Power on your notebook PC.
Software Installation
This section will guide you through the installation of
your 1394 Dual-Port CardBus.
Windows 98SE Driver Installation
1.
At the Add New Hardware Wizard, click Next.
2.
Choose Search for the best driver for your device,
and click Next.
3.
Uncheck all the boxes, click Next, Next, Next.
Note: If you are prompted to insert your Windows
Installation CD-ROM, insert it and click OK.
4.
Click Finish, then restart Windows to complete the
driver installation.