Shark V1911TR - Manual (Page 8)

OPERATING INSTRUCTIONS
6
Fig. 6
4. Carefully lift out the battery pack and push on the release tab on the terminal
connector before separating the wire terminal connectors. Remove the battery
pack from the unit. (Fig. 6)
5. Connect the wire terminal connector from the unit to the wire terminal connector of
the new battery pack, and replace the battery pack into the unit. Replace the cover
and press until it snaps in place.
6. Follow instructions for initial battery charging. Please call customer service at
1 (800) 798-7398 if there are any problems removing batteries.
Do NOT attempt to replace the batteries used in this product with any other type of
battery.
Important: This appliance contains Ni-Cd batteries. The batteries must be
recycled or disposed of in accordance with local regulations. Please consult your
Yellow Pages or local recycling center for more information.
Wire Terminal Connector
Removal of Battery Pack
1. Press the dust cup release pedal with your foot and remove it from the sweeper
power head.
2. Turn unit over so that the base is facing upwards. Be careful not to turn the unit
ON.
3. Push in locking tab and lift off battery compartment cover. (Fig. 4 & 5)
Fig. 4
Battery Case Tab
Battery Pack
Compartment Cover
Fig. 5
How To Operate Your Cordless Sweeper
1. Before using, please ensure that the cordless sweeper has been initially
charged for 20 hours.
Your cordless sweeper will only operate properly when the batteries are fully
charged. Your sweeper will operate for varying lengths of time on a full charge.
This will depend upon the type of surface being cleaned. (Longer operating time on
bare floors vs. carpets.)
2. Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 7)
7
OPERATING INSTRUCTIONS
3. To release the handle to a comfortable position, apply pressure to the top of the
sweeper head with your foot while pulling back on the handle. (Fig. 8)
4. To change the speed of the brush roll, press the speed control button once. One
light “On” indicates the unit is on the optimal speed for cleaning hard floors. Two
lights “On” indicate the unit is on the optimal speed for cleaning carpets.
Anti-Jam Brush Roll Feature
This feature protects your unit’s motor from damage due to overheating, that may be
caused by the rotating brush gets jammed or tangled in something. If the rotating brush
becomes overloaded it will stop turning and both speed indicator lights will remain lit at
the same time. To reset the unit:
1. Press the “On/Off” switch.
2. Remove the transparent brush cover from the sweeper power head to remove any
build up of lint, hair or fiber on the rotating brushes.
3. Wait for 10 seconds to allow the unit to cool down.
4. Press the “On/Off switch again, the unit should restart.
"On/Off“ switch
Fig. 7
Fig. 8