Tire sealant and compressor kit storage, Changing a flat tire, Tire sealant and – Saturn 2009 OUTLOOK User Manual

Page 356: Compressor kit storage -70, Changing a flat tire -70

Advertising
background image

Tire Sealant and
Compressor Kit Storage

The tire sealant and compressor
kit is located in the storage
compartment on the driver side,
at the rear of the vehicle.

1. Press down on the latch tab and

pull the cover off to access the
storage compartment.

2. Press the two tabs on the quick

release buckle to release the tire
sealant and compressor kit strap.

3. Remove the sealant and

compressor kit from its tray.

To store the tire sealant and
compressor kit, reverse the steps.

Changing a Flat Tire

If a tire goes flat, avoid further tire
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See Hazard
Warning Flashers
on page 3-5.

{

CAUTION

Changing a tire can be
dangerous. The vehicle can slip
off the jack and roll over or fall on
you or other people. You and they
could be badly injured or even
killed. Find a level place to
change your tire. To help prevent
the vehicle from moving:

1. Set the parking brake firmly.

2. Put the shift lever in

P (Park).

3. Turn off the engine and do

not restart while the vehicle
is raised.

4. Do not allow passengers to

remain in the vehicle.

To be even more certain the
vehicle will not move, you should
put blocks at the front and rear of
the tire farthest away from the
one being changed. That would
be the tire, on the other side, at
the opposite end of the vehicle.

5-70

Service and Appearance Care

Advertising