Owner's manual, Aa35 mixer amplifier, Wiring the aa35 – Soundolier AA35 User Manual
Page 16: Security cover option
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP
Printed in U.S.A.
000106
ATS002171 RevA 01/06
PP
OWNER'S MANUAL
AA35 MIXER AMPLIFIER
16
WIRING THE AA35
Speaker Outputs - Use 2 conductor unshielded wire of the appropriate gauge. If you are unsure about
this, contact Atlas Sound Tech Support at 1-800-876-3333. Make sure you know how many speakers you
need and what tap value you intend to use.
Mic/Line Input - Use 2 conductor w/ shield for low level signals of 20-22 gauge is best. Maintain the
proper polarity, + to +, – to – , and shield to ground.
Unbalanced Inputs and Outputs - Pre-made RCA cables can be purchased from vendors to simplify
interconnection to external devices.
Zone 2 Out - Use 2 conductor, 20-22 gauge, shielded is best. Terminate the shield at the input to the
device if possible.
SECURITY COVER OPTION
In order to prevent unauthorized operation of the AA35, optional security covers are available which take
the place of the front panel knobs. After the AA35 has been installed and is operating as desired, grasp
the front panel knobs and pull straight out from the front panel. Replace the knobs with security covers,
Atlas part number AAVCC-5, available in quantities of 5.
Power
On
Off
Signal
Power
Peak
Treble
n
Bass
Input 3
Input 2
Input 1
n
77)+C_n[h7cfb_\_[h
Front Panel
Knob
or
Security Cover