Shark S3401 - Manual (Page 4)

2 TOLL FREE: 1-800-798-7398 3 www.sharkclean.com
English
FILLING THE WATER TANK
1 Open the water tank cap by lifting
the cap up to the open position
(
fig. 3).
2 A filling flask is included with your
Vac-Then-Steam™ and hand steamer
to make filling the water tank easy.
Fill the flask with water and use the
funnel to pour it into the tank.
Keep the water level under the
MAX FILL line.
3 Close the water tank cap by pressing
the cap down to the closed position.
Getting Started
a Hand Steamer
b 1 Micro-Fiber Cleaning Pad
c 1 Micro-Fiber Cleaning Bonnet
When assembling your Shark ® Handheld
Steam Scrubber there may be a little
water in or around the water tank. This
is because we test all our steam cleaners
100% before you buy them, so you get a
quality hand steamer.
a
b
c
fig. 1 fig. 2 fig. 3
ATTACHING THE MICRO-FIBER PAD
1 Place the micro-fiber cleaning pad
on a flat surface with the quick
fastener strips facing up. Place the
hand steamer
on the top of the pad
to attach ( fig. 1).
IMPORTANT: Never use the hand
steamer
without attaching a micro-
fiber cleaning pad or bonnet to avoid
damage to your hard surfaces.
ATTACHING THE MICRO-FIBER
BONNET
1 Align bonnet and hand steamer so
that the purple tag is at the rear of
the hand steamer. Insert front of
the hand steamer into the bonnet
and use the purple tag to gently pull
bonnet over the base of the hand
steamer (
fig. 2).
Replacement micro-fiber pads and
bonnets are available at
www.sharkclean.com or by calling
1-800-798-7398.
Use the pad for quick clean
up and use the shaggy bonnet
for scrubbing heavier messes.