Southwing SA505 - Manual (Page 5)

9
HOW TO? ACTION HEADSET RESPONSE
Power On Move power switch to ON. Headset turns on and light flashes blue and
red.
Power Off Move power switch to OFF. Headset turns off.
Volume up In ON state, press Vol+ Button repeatedly Every press you hear a beep
Volume down In ON state, press Vol- Button repeatedly Every press you hear a beep
Pairing Mode In ON state press and hold Play Button for 5 sec and
see the pairing instructions of your phone
Headset light flashes blue and red
Accept call During incoming call, slide microphone down Headset picks call up
Reject Call 1 During incoming call press and hold Play Button for 1
sec
Headset rejects call
Cancel outgoing call During outgoing, call press and hold Play Button for 1
sec
Headset cancels call
Voice Dialling 2 In ON state, slide microphone down, press Play Button
once
Headset beeps and mobile initiates the
voice dialling command
Push4 call to favourite
number 1
In ON state, slide microphone down, press and hold
Backward Button for one second
Headset makes a call to the stored
Favourite number
Push4 call to pre-config-
ured number 1
In ON state, slide microphone down, press and hold
Forward Button for one second
Headset makes a call to the pre-configured
number
End Call Slide microphone up Headset hangs up the current call
Disconnect from phone 1 With the microphone up, press the Play Button 3 times Headset disconnects from phone
Connect to phone 1 With the microphone up, press the Play Button 2 times Headset connects to phone
Connect to / Disconnect
from music player
With the microphone up, press and hold the Forward
and Backward Buttons at the same time for 1 second
Headset connects to / disconnects from
music player
Memorize Favourite
Number from incomming
call
With the microphone up, press and hold the Backward
Button for 3 seconds
Headset stores the last calling number
to the Favourite number
Mute / Unmute micro-
phone
During a call press and hold the Volume + and the
Volume – Buttons at the same time for 2 seconds
Microphone is muted / unmuted and peri-
odic tones are heard if muted
Transfer call to mobile 1 During a call press Play Button 3 times Call continues in mobile
Transfer call back to
Headset 1
During a call in the mobile press Play Button once Call continues in Headset
Automatic call pick up
activation
In ON state, press Play Button 5 times Select Automatic call pick up mode
Play music 3 With the microphone up, press the Play Button once The music player will start playing music
Pause / Resume music 3 Press the Play Button once Music will pause if playing or resume if
paused
Stop music 3 Press the Play Button twice Music will stop
Skip one track forward or
backward 3
Press the Forward or Backward Button once Music player will go to next or previous
track
COMMANDS SUMMARY TABLE
1 Only with mobile phones supporting Hands-free mode · 2 Only with mobile phones supporting voice dialling · 3 Only with mobile phones and /or pc
dongles supporting AVRCP profile.
9. DECLARATION OF CONFORMITY
Hereby, SouthWing S.L., declares that this
Bluetooth Stereo Headset is in compliance
with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
CE0336
FCC Statement ( Federal Communications
Commission, USA)
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may
not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
The FCC requires the user to be notified
that any changes or modifications made to
this device that are not expressly approved
by SouthWing may void the user’s authority
to operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digi-
tal device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful inter-
ference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be deter-
mined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by 1 or more of the following
measures:
· Reorient or relocate the receiving antenna
· Increase the separation between the
equipment and receiver
· Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected
· Consult the dealer or an experienced radio
or television technician for help
This product emits radio frequency energy,
but the radiated output power of this device
is far below the FCC radio frequency expo-
sure limits. Nevertheless, the device should
be used in such a manner that the potential
for human contact with the antenna during
normal operation is minimized.
8
This product follows the WEEE (Waste Electrical and Electronic Equipment) requirements.
2002/96/EC