Sound Performance Lab 9737 - Manual (Page 11)

11
Machine Head
Storing a preset:
Depress S TORE for1 sec.,
LED flashes;
use U
P /D OWN to select
preset no.;
depress S
TORE again,
LED goes out, preset is
stored
Applying a preset:
Depress A PPLY for1 sec.,
LED flashes;
use U
P /D OWN to select
preset no.;
depress A
PPLY again,
LED goes out, preset is
applied
Operation safety:
Presets can not be changed
by accident
9
The D RIVE L EVEL metering shows the recording level of the
“virtual tape machine”. The display range is -10 dB to +21 dB.
The D
RIVE L EVEL ist adjusted with the D IRVE control (see 3).
The O UTPUT PPM meters show the peak level after the O UTPUT
G AIN control (see 5).
The first LED in each I NPUT and O UTPUT PPM meter is a signal
(S IG .) LED to indicate that a valid digital source is connected and
detected. This LED helps you to verify the signal flow within a
digital processing chain. If one S
IG . LED is not illuminating you
have a first indication of a faulty digital signal flow.
The last LED of each I NPUT and O UTPUT PPM meter is a C LIP
LED. The LED illuminates if the digital signal is too hot causing
digital distortion.
The M ACHINE H EAD allows you to store up to 99 presets, which
can be changed by MIDI program change command.
If you want to store a new adjustment, depress S TORE for one
second. The LED starts to flash indicating that the S TORE mode
has been activated. The LC-display now shows the values of the
presets (including the B
OOST function) before the M ACHINE H EAD
was switched off the last time. Use U P and D OWN to select a
new preset number. The status-LED flashes shortly to indicate
that the input (depressing U
P or D OWN ) is accepted. Keeping U P
or D OWN depressed will let you jump through the preset list in
steps of 5 presets. Once a new preset location is found depress
S
TORE again. The S TORE LED goes out. The preset is stored at the
new location.
In case you want to quit the S TORE mode without storing the
new adjustments simply press A PPLY .
If you want to apply various presets depress A PPLY for one
second. The A PPLY LED starts to flash indicating that the A PPLY
mode is activated. You can step through the preset list with U P
and D OWN . Once you have a preset that you want to apply
depress A PPLY again. The A PPLY LED goes out indicating that the
preset is applied.
In case you want to quit the A PPLY mode without applying the
new preset simply press S TORE .
NOTE: To increase operation safety it is impossible to apply
presets by simply depressing U P or D OWN . The U P and D OWN
status-LEDs will not flash indicating that the input is not
accepted. You have to depress S
TORE or A PPLY for one second in
order to activate the U P and D OWN buttons.
Presets
Control Elements