Snap-On 870016 - Manual (Page 7)

To select Contact Sequential Actuation Mode (see Figure 2):
1. Press and hold Actuation Selector embedded in the
trigger.
2. Rotate Actuation Selector up to the Contact
Sequential Actuation (TTT).
3. Release Actuation Selector, ensuring locking tab is
fully seated in the slot.
Ensure selector has locked into position. Ensure
actuation process is fully understood before attempting to use brad nailer.
TO USE THE BRAD NAILER IN CONTACT ACTUATION MODE:
1. Firmly grip brad nailer handle.
2. Pull and hold the brad nailer trigger.
3. Push brad nailer against work piece compressing work piece contact.
4. The brad nailer will drive nail upon contact. The brad nailer will recoil away
from the work piece as nail is driven.
ADJUSTING DEPTH OF NAILING
Be aware of material thickness when using nailer. A pro-
truding nail may cause injury.
Adjust the depth of nailing by turning the
adjustment knob (Figure 3, Item 1) to the left (A)
for the shallowest setting and to the right (B) for
the deepest setting. To increase the depth of the
nails, when the adjustment knob is already set to
its lowest setting, increase the air pressure. To
decrease the depth of nails when the adjustment
knob is already set to its highest setting,
decrease the air pressure. Should nails be driven
too deep even when the adjustment knob is set
at its lowest setting, decrease the air pressure. In
general, the brad nailer will have a longer service
life when the adjustment knob is set at a lower
setting causing less wear and tear on the driving
mechanism.
Always disconnect the brad nailer before making any
adjustments to the nail depth knob.
USING THE HOOK
Always disconnect the air hose before hanging the brad nailer with the hook.
NEVER hook the brad nailer in a high location or on an unstable platform.
LOADING NAILS INTO THE AIR NAILER
Always disconnect the air hose from the brad nailer before adding or remov-
ing nails to the brad nailer.
NEVER use deformed nails or nail strip. Failure to observe this precaution
can result in poor nail feeding and/or jams in the feeding mechanism.
To load nails in brad nailer, depress magazine lever and pull magazine cover to back
of magazine. (Figure 4). Insert nails and slide magazine cover over nails until it locks
into place.
USING THE NO-MAR NOSEPIECE
Always disconnect the air hose before attaching the
no-mar nosepiece.
11 12
Figure 3
Figure 4
Figure 2