Stoelting E112 User Manual
Page 16
10
3.6 REMOVING MIX FROM FREEZER
To remove the mix from the freezer, refer to the following
steps:
A.
If removing shake mix, pull the mix inlet regulator
straight up and remove it from the hopper.
B.
Place the switch in the CLEAN position to rotate
the auger. Allow the mix to agitate in freezing
cylinder until the mix has become liquid, about 5
minutes.
C.
Drain the liquid mix by opening the spigot. A
container should be placed under the spigot to
collect the liquid mix.
D.
Place the switch in the OFF (middle) position.
3.7 CLEANING THE FREEZER
NOTE
The frequency of cleaning the freezer and freezer
parts must comply with local health regulations.
After the mix has been removed from the freezer, the
freezer must be cleaned. To clean the freezer, refer to the
following steps:
A.
Close the spigot and fill the hopper with 2 gallons
(8 liters) of tap water.
B.
Place the switch in the CLEAN position. The
auger will start to rotate.
C.
Allow the water to agitate for approximately 30
seconds.
D.
Open the spigot to drain the water. Remember to
place a container under the spigot to catch the
water. When the water has drained, place the
switch in the OFF (middle) position. Allow the
freezing cylinder to drain completely.
E.
Prepare detergent water by mixing 2 oz. of
Palmolive detergent or equivalent in 2 gallons of
90° to 110°F (32° to 43°C) water. Repeat steps A
through D using the detergent solution.
3.8 DISASSEMBLY OF FREEZER PARTS
Inspection for worn or broken parts should be made each
time the freezer is disassembled. All worn or broken parts
should be replaced to ensure safety to both the operator
and the customer and to maintain good freezer perfor-
mance and a quality product. Frequency of cleaning must
comply with the local health regulations.
To disassemble the freezer, refer to the following steps:
A.
Remove hopper cover. Remove the mix inlet
regulator from the hopper.
B.
Pull out the spigot pin by its ring (Refer to Figure
3-4).
C.
Remove the spigot handle.
D.
Remove front door by turning the circular knobs
and then pulling door off the studs.
NOTE
When removing front door, entire door and stator
assembly will come out as well.
E.
Remove torque rod from stator assembly.
F.
Remove quad ring from groove in front door.
G.
Remove stator bar. Remove o-ring and white
bushing from stator bar.
H.
Remove auger support bushing.
I.
Turn the spigot body until the ice breaker bar can
be removed. Remove breaker bar (Refer to Figure
3-5).
CAUTION
Hazardous Moving Parts.
Revolving auger shaft can grab and cause injury.
Place the switch in the OFF (middle) position be-
fore disassembling for cleaning or servicing.
Figure 3-5 Spigot and Ice Breaker Bar Removal
Figure 3-4 Remove Spigot Pin