Smeg DO10PSS - Manual (Page 5)

Instructions for the user
31
5. ELECTRONIC ANALOGUE CLOCK (ONLY ON SOME MODELS)
The programmer user instructions are valid only for the large oven.
LIST OF FUNCTIONS
MINUTE-MINDER BUTTON
AUTOMATIC DURATION / AUTOMATIC STAR TIME BUTTON
TIME SETTING AND RESET
DECREASE TIME BUTTON
INCREASE TIME BUTTON
5.1 Setting the time
When the oven is used for the first time, or after a power failure, the display flashes on and off at
regular intervals. Press the
key for 1 to 2 seconds to stop the display flashing and start setting of
the current time. Press the or keys to increase or decrease by one minute each time a key is
pressed.
Press one of the two value modification keys until the current time appears. The clock will start from
the time set 6/7 seconds after the last key is pressed.
At the end of each programmed cooking operation, an intermitant alarm will sound 3 to 4 times at
intervals of about 1 and a half minutes. The beeps can be stopped at any moment by pressing any
key.
5.2 Minute-minder
This function does not stop cooking but just triggers the alarm.
- When the key is pressed the display illuminates, appearing as shown in
figure 1;
- Press the or keys within 6 to 7 seconds to set the minute-minder.
Whenever a key is pressed, 1 outside segment, representing 1 cooking
minute will light up (figure 2 shows 10 cooking minutes).
1
- The countdown will start 6 to 7 seconds after the last key is pressed; at the
end of it, you will hear the alarm.
- During cooking with countdown, the current time can be displayed by
pressing the key once; press again to return to the minute-minder display.
- At the end of the countdown, the oven has to be switched off by hand,
by turning the thermostat and the function selector to 0.
2