Sunbeam KE7500 - Manual (Page 6)

4
Before using your kettle.
Fill the kettle with water up to the maximum
level indicator, boil and discard.
Dual-use switch.
This kettle features a dual function switch.
Push the upper section of the switch ‘
’ to
turn the kettle ‘On’. Push the lower section
of the switch ‘
‘ to pop open the lid.
Using your kettle.
1.Push down the lower section of the switch
‘ ‘to open the hinged locking lid.
2.Fill the kettle with the desired amount of
water (minimum 1 cup / 250ml).
NOTE: Do not fill above the maximum level
indicator (marked on the water gauge as
“MAX”) as water may spill out of the
spout when boiling.
Alternatively, the kettle may be filled
through the pouring spout.
3.Push the lid closed firmly until it locks
into position.
4.Place the kettle on the power base and
connect the plug into a 230/240 Volt AC
power outlet. Turn the power ON.
5.Press the ON ‘ ’ switch. The light will
illuminate to indicate the kettle is heating.
6.The kettle will switch off automatically
once the water has boiled.
Note: Do not remove the kettle from the
power base while in use.
7.Lift the kettle from the power base and
pour the water.
8.The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON switch is pressed.
Note: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, it will cut out for
boil-dry protection. If this occurs, allow the
kettle to cool before filling with cold water
and re-boiling.
Cord Storage Facility.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
Using your Alur Stainless
360° power base
Dual use switch
Power
Open lid