Sony SU-FL62 - Manual (Page 18)

6
(GB)
Step 2:
Assembling the Floor
Stand
If you allow the AC power cord to be pinched under or
between pieces of equipment, this may result in a short
circuit or an electric shock. If you stumble over the AC
power cord or the connecting cable, the Floor Stand may
topple over and cause injury.
Decide on the installation location and lay the
Floor Stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide
on the installation location beforehand, and assemble the
Floor Stand on site.
1
Detach the Front and Rear Pillar
Support Panels from the Center
Pillar.
WARNING
Front Pillar
Support Panel
Rear Pillar
Support Panel
2
Attach the Center Pillar to the
Frame.
Match the screw holes of the Frame and the “F” marks
of the Center Pillar and secure them with the four
supplied screws (+PSW5 × L25).
• Be sure that two or more persons assemble the Floor Stand.
• Loosely attach the Center Pillar to the Frame with the four
screws, then tighten all screws sufficiently.
• When using an electric screwdriver, set the torque setting
to approximately 1.5 N·m {15 kgf·cm}.
3
Attach the Front Pillar Support
Panel.
Before attaching the Front Pillar Support Panel, check that
the four screws are firmly tightened.
Screw
(+PSW5 × L25)
Frame
Notes
Note