Sony KF-E42A10 - Manual (Page 55)

55 GB
Addi
ti
onal
I
n
fo
rmat
ion
The remote does not function • Check that the remote is set correctly for the equipment you are using
(VCR, TV, or DVD).
• If the remote does not operate the VCR or DVD even when the remote has
been set correctly to VCR or DVD, enter the necessary code set as explained
in “Programming the remote” (page 45).
• Replace the batteries.
• If the “High Temperature Warning!” message appears, turn off the TV and
wait until the TV’s projection lamp cools down (approximately 5 minutes).
If the remote control still does not work, make sure to dust the ventilation
slots on the rear of the TV and the cooling fan to provide adequate
ventilation around the TV.
The LAMP indicator blinks in
red • Replace the lamp (see page 48).
The TV does not turn on • The TV cools down its projection lamp when the power is turned off. It
takes up to two minutes for the picture to come back after the TV is turned
on again. Wait for a while until the picture comes back.
The wide screen mode
changes spontaneously when
“Auto Wide” is “On” • During a transition between two programs, the TV detects the optimum
wide screen mode. During this period, an irregular wide screen mode may
appear.
• The wide mode is switched automatically according to the revised signal
with a Wide ID signal.
• The Auto Wide feature stops working temporarily when you press , and
resumes after a while. To fix in the manually selected wide screen mode, set
“Auto Wide” to “Off” in the “Screen” menu (page 33).
“100” appears at the top of the
screen after approximately 10
seconds and there is no
teletext display • The channel carries no Teletext broadcast.
Teletext display is incomplete
(snowy picture or double
images) • Your area may not be able to receive Teletext. Teletext is displayed only in
the area that is covered by Teletext services.
• The antenna connection is loose or the antenna cable is damaged. Check the
cable and connection on the TV, VCR, and on the wall (page 14).
• The antenna direction needs adjustment. Adjust the antenna direction.
Contact a Sony dealer for advice.
• Signal transmission is too low. Try using a booster. Otherwise, use the fine
tuning (“Fine”) function (page 35).
Cannot play shooting games • Some shooting games which involve pointing a light beam at the TV screen
with an electronic gun or rifle cannot be used with your TV. For details, see
the instruction manual supplied with the video game software.
The TV cabinet creaks • Changes in room temperature sometimes make the TV cabinet expand or
contract, causing a noise. This does not indicate a malfunction.
Static discharge is felt when
touching the TV cabinet • This is the same static discharge that is felt when touching metal door
handles or car doors especially when the air is dry, for example in winter.
This does not indicate a malfunction.
Problem Cause/Remedy