Sony DAV-DZ210D - Manual (Page 71)

Ad
v
a
nc
ed Settings and Adjus
tments
71 GB
Be sure to change the value in the Setup Display
when you move the speakers.
* When you perform the Quick Setup (page 16), the
default settings are changed.
** 0.0 to 6.9 meters for North American models.
Note
• If all front and surround speakers are not placed at an
equal distance from your listening position, set the
distance according to the closest speaker.
• Do not place the surround speakers farther away from
your listening position than the front speakers.
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
To adjust the volume of all the
speakers at one time
Turn the VOLUME control on the system, or
press VOLUME +/– on the remote.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
Adjusting the speaker level by
using the test tone
1
Press DISPLAY when the system is
in stop mode.
The Control Menu appears.
2
Press X/x to select [SETUP],
then press ENTER.
The options for [SETUP] appear.
3
Press X/x to select [CUSTOM], then
press ENTER.
The Setup Display appears.
4
Press X/x repeatedly to select
[SPEAKER SETUP], then press ENTER
or
c.
5
Press X/x repeatedly to select [TEST
TONE], then press ENTER or c.
[L/R]
3.0 m/10 ft
*
(appears when you
set [SURROUND]
to [YES] in the
[SIZE] setting.)
Surround speaker distance from
the listening position can be set in
0.2 meter (1 ft) increments from
0.0 to 7.0 meters** (0 to 23 ft).
[L/R]
0.0 dB Set this between –6.0 dB and 0.0
dB in 1.0 dB increments.
[CENTER]
0.0 dB
(appears when you
set [CENTER] to
[YES] in the [SIZE]
setting.) Set this between –6.0 dB and +6.0
dB in 1.0 dB increments.
[SUBWOOFER]
0.0 dB Set this between –6.0 dB and +6.0
dB in 1.0 dB increments.
[L/R]
0.0 dB
(appears when
you set
[SURROUND] to
[YES] in the
[SIZE] setting.) Set this between –6.0 dB and +6.0
dB in 1.0 dB increments.
[OFF] The test tone is not emitted from the
speakers.
[ON] The test tone is emitted from each speaker
in sequence while adjusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
continued