Shibaura E673L - Manual (Page 24)

24 109821_0508
NOTE:
1. The service intervals after 1000 operation hours should also be made every 100 operation hours in accordance with this
check and maintenance schedule.
2. When the servicing on the asterisked ( * ) items are necessary, consult the equipment supplier.
Explanation of Maintenance Schedule
The following is a brief explanation of the services listed
in the preceding Engine Maintenance schedule.
1. Oil level and condition of oil Check that the oil level is between the max. level mark and the min. level mark. Drain
oil to the max. level mark If oil level is above the max. level mark. Add oil to the max.
level mark if oil is below the min. level mark.
2. Oil leakage check Replace any damaged or malfunctioning parts which could cause leakage.
3. Oil pressure warning lamp Warning lamp is off while engine running. If it stays on, check and repair the lubrication
system.
4. Engine oil replacement Change oil per specified interval.
5. Oil filter element replacement Change element per specified interval.
6. Fuel leakage check Inspect the fuel lines for damage which could cause leakage. Replace any damaged or
malfunctioning parts.
7. Draining water in fuel filter Drain the sedimented water in fuel filter every 100 hours.
8. Fuel filter element replacement Change element every 200 hours.
9. Injection nozzle check Check and adjust injection opening pressure and spray condition (This is a recom-
mended maintenance) every 1000 hours.
10. Coolant level and condition Check coolant level and add coolant if necessary.
check
11. Coolant leakage check Repair or replace parts as required.
12. Radiator filler cap The radiator cap must be installed tightly.
fitting condition
13. Fan belt tension check Check and adjust fan belt tension. Look for cracks, fraying and wear.
14. Overheat warning lamp Coolant temperature is normal at about 75° to 90°C (167° to 194°F)
NO Description of check and Maintenance
Daily Initial
50
Every
100
Every
200
Every
400
Every
600
Every
1000
Remarks
17 Cooling system circuit cleaning Yearly
See
'
EXPLANA
T
ION OF M
A
INTENANCE S
H
EDULE'
18 Radiator filler cap function check (*) X
19 Electrolyte level check X
20 Battery cleaning X
21 Battery charge con-
dition Charge warning
lamp
X
22 Electrolyte gravity check X
23 Starter and alternator check and cleaning(*) X
24 Wiring and connection check X
25 Preheating condition check X
26 Air cleaner element replacement X
27 Engine starting conditions and noise condi-
tions
X
28 Exhaust smoke condition X
29 Cylinder compression pressure(*) Every 2000 hours
30 Valve clearance check (*) X