Sirius Satellite Radio SDC-313B - Manual (Page 17)

Camera Operation
COLOR CCD CAMERA User’s Manual 33 COLOR CCD CAMERA User’s Manual 32
5) When a name has been chosen, please select a position for the name display.
Please move the cursor onto 'POS' and then press the SETUP button.
The name will appear at the top left hand
corner.
Please find the position you wish to display the
name by using the 4 directional buttons,
and then press the SETUP button.
6) Please select 'END' and then press the SETUP button to complete ID input.
to Locate, then SET to Locate, then SET to Locate, then SET
FRONT DOOR
to Locate, then SET
FRONT DOOR
Camera ID
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
- . 1 2 3 4 5 6 7 8 9
CLR POS END
SYNC : Two SYNCHRONIZATION modes are available INTERNAL and EXTERNAL
LINE-LOCK. In LINE-LOCK mode, it synchronizes the video signal between
cameras without a synchronous generator. The line-lock synchronization is only
used in the areas of 60Hz(NTSC Model) / 50Hz(PAL Model)
- INT : Internal synchronization - LL : External line-lock synchronization
• If you choose ‘LL’, you can adjust the desired phase.
Press the SET button.
• You can adjust the desired phase from 0 to 359.
• When the power frequency is 50Hz, you can not use line-lock mode (NTSC MODEL).
• When the power frequency is 60Hz, you can not use the line-lock mode(PAL MODEL).
• 'Sync' mode is fixed to 'INT' in DC12V input power.
Notes
MOTION DETECTION:
This product has a feature that allows you to observe movements of objects in 4
different areas on the screen, and the words 'MOTION DETECTED' appear on the
screen when movement is detected; hence a single individual can conduct
supervision efficiently. The camera detects an object's movement by sensing
disparity of outline, and level of brightness and color.
• Please press the SETUP button.
- OFF : MOTION DETECTION mode is cancelled.
- ON : Any motion in the selected areas is observed.
• Please select the area you wish to observe from the 4
areas in AREA SEL mode.
• Please select ON mode for the chosen area.
• Please adjust the size of the area to be observed by
using the UP, DOWN, LEFT or RIGHT button.
•Please press the SETUP button to save the changes and complete the setting.
•There is no ‘MD’ output signal. ‘MD’ is on screen display only words.
Notes