Smeg FAB28MCUS - Manual (Page 4)

Instructions for the Installer
6
3. INSTALLATION INSTRUCTIONS
3.1 Unpack the Refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
3.1.1 Remove the Packaging
• Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount
of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your refrigerator. For more information, see “en.”
• On some models, shelves, bins, door shelf rails, and other feature parts may be packaged in the
Interior FeaturePak. Follow the instructions contained in the package for proper assembly.
• Properly dispose of packaging.
When Moving Your Refrigerator:
•
Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the
floor.
• Always pull the refrigerator straight out when moving it.
• Do not wiggle or “walk” the refrigerator when trying to move it, as floor damage could occur.
3.1.2 Clean Before Using
After you remove all of the package materials, clean the inside of your refrigerator before using it. See
the cleaning instructions in “6. REFRIGERATOR CARE.”
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may
break if exposed to sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is
normal. Glass shelves and covers are heavy. Use special care when removing them to avoid impact from
dropping.