Siemens 9000407137(8811) - Manual (Page 8)

en
8
Switching off salt refill
indicator/water softening
system
If the salt refill indicator
5
is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
Proceed as described under “Setting
water softening system” and set the
value to
.
The water softening system and salt
refill indicator are now switched off.
Warnings
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
To prevent corrosion, always refill with
salt immediately before switching on the
appliance.
Rinse aid
As soon as the rinse-aid refill indicator
6 lights up on the control panel,
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21
_ dH (37 _ fH, 26 _ Clarke,
3,7 mmol/l) only. If the water hardness
is over 21
_ dH, rinse-aid must be used.
Open the dispenser
29
by pressing
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.