SOYO SY-6VZA - Manual (Page 7)

SY-6VZA Quick Start Guide
7
Hardware Installation
Step 2.
Make Connections to the Motherboard
This section tells how to connect internal peripherals and power supply to the Motherboard.
Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Chassis Fan,
Front Panel Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock
Switch.), Wake-On-LAN card, VGA card, Sound Card, and other devices.
For more details on how to connect internal and external peripherals to your new SY-6VZA
Motherboard, please refer to SY-6VZA Motherboard User's Guide and Technical Reference
online manual on CD-ROM.
Connectors and Plug-ins
IrDA (Infrared Device Header): IR1 Wake-On-LAN Header: JP44
Pin1 Pin2 Pin3 Pin4 Pin5 Pin1 Pin2 Pin3
VCC None IRRX GND IRTX 5VSB GND MP-Wakeup
CPU Cooling Fan: CPUFAN Chassis Fan: CHAFAN
Pin1 Pin2 Pin3 Pin1 Pin2 Pin3
GND 12V SENSOR GND 12V SENSOR
CD Line-in:J4,J5 Pin1 Pin2 Pin3 Pin4
J4 L G G R Connect the CD Line-in cord from the CR-ROM device to
the matching connector J4 or J5
J5 L G R G
Power LED Keylock
Pin1 Pin2 Pin3 Pin1 Pin2
5V NC GND Control Pin GND
Speaker
Pin1 Pin2 Pin3 Pin4
5V NC NC Speaker out
HDD LED Turbo LED PWRBT RESET
Pin1 Pin2 Pin1 Pin2 Pin1 Pin2 Pin1 Pin2
LED Anode
LED
Cathode
LED
Cathode
GND
Power
On/Off
GND
Power
Good
GND
ATX Power On/Off: PWRBT
Connect your power switch to this header (momentary switch type).
To turn off the system, please press this switch and hold down for longer than 4 seconds.
ATX Power Supply: ATX PW
Attach the ATX Power cable to this connector. If you use ATX power supply.
When using the Power-On by PS/2 Keyboard function, please make sure the ATX power supply can
take at least 720mA load on the 5V Standby lead (5VSB) to meet the standard ATX specifications.
1
1 1 1 1
1 1
Power LED Key Lock Speaker
Reset PWRBT Turbo LED HDD LED