Sun Lawn EM-1 - Manual (Page 5)

Owner’s Manual — Sunlawn EM-1
3
ASSEMBLE THE HANDLE SECTIONS
1. Set the cutting height to the highest setting. (See Operation section
– Adjusting the cutting height, page 7). This will make it easier to
attach the lower handle section.
2. Fit the lower section of the handle so that the holes are over the
handle posts on the mower. Then rock the handle to align the locking
tabs and allow the handle section to fit into place.
3. Continue assembly of the middle and top sections of the handle
using the handle bolts and wing nuts. The top section must be
attached with the two holes near the grip area on the right side
(standing behind the mower).
Bottom Handle Mount Hole
Top / Middle Handle Mount Hole
CAUTION
Be careful to keep the mower upright. When
the battery cover is not latched and the mower
is not upright, the batteries may fall out
causing damage to the batteries or the electric
circuits.
!