Soleus Air JC-128E - Manual (Page 5)

5
OPERATION
Unpacking the Wine Cooler
1) Remove the exterior and interior packaging.
2) Make sure that all the package contents are included with your wine cooler.
It is advisable to clean the inside of the wine cooler with lukewarm water and a soft cloth, and then to dry
it thoroughly prior to use.
3) Find a location for your unit that is protected from direct sunlight and other sources of heat. Place the unit
on a level surface. Make sure that there is at least 5 inches of space between the back of your unit and
the wall. Avoid locating the appliance in moist areas. Too much moisture in the air will cause
condensation to form, requiring more frequent defrosting of the unit.
4) Allow one hour for the refrigerant fluid to settle before plugging it in.
The refrigeration system of the cabinet is designed to operate with the cabinet located on a flat surface.
Avoid tilting the cabinet side.
Connecting the Wine Cooler
Improper use of the grounded plug can result in the risk of electrical shock.
This unit should be properly grounded for your safety. The power cord is equipped with a three-prong plug
which mates with standard three-prong wall outlets to minimize the possibility of electrical shock.
Plug your appliance into an exclusive, properly installed, grounded wall outlet. DO NOT under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and or grounding should be directed toward a certified electrician.
This appliance requires a standard 115/120volt, 60Hz electrical outlet with three-prong ground.
Operating the Wine Cooler
1) Press the up or down arrow buttons to set the desired temperature between 39-60°F.
2) Press the °C/°F button to change temperature display from Centigrade to Fahrenheit, if necessary.