Smart Technologies 480i5 - Manual (Page 7)

Cleaning
C
C A U T I O N
l Before you clean the projector, press the Power button twice on the remote control to put
the system in Standby mode, and then allow the lamp to cool for at least 30 minutes.
l
Do not spray cleaners, solvents or compressed air near any part of the projector because
they can damage or stain the unit. Spraying the system could spread a chemical mist on
some of the projector’s components and lamp, resulting in damage and poor image quality.
l
Do not allow liquids or commercial solvents of any kind to flow into the projector.
I
I M P O R T A N T
l
Put your SMART product into Standby mode before cleaning it.
l
Follow these guidelines to clean the projector:
o Wipe the exterior of the projector with a lint-free cloth.
o If necessary, use a soft cloth moistened with a mild detergent to clean the projector
housing.
o Do not use abrasive cleaners, waxes or solvents.
o Avoid touching the lens. If it is necessary to clean the lens:
o Use liquids or commercial solvents (such as glass cleaners) to clean the lens,
but do not spray them directly on the system.
o Use protective gloves and dip a lint-free cloth (such as Purestat PW2004) in an
anti-static solvent (such as Hyperclean EE-6310).
o Gently wipe the lens from the center to the edge. Do not apply any pressure to
the lens.
Service
C
C A U T I O N
l
Do not adjust any settings in the service menu other than those listed in the following
procedures. Changing other settings might damage or affect the operation of your projector
and may invalidate your warranty.
I M P O R T A N T I N F O R M A T I O N
v