Using the remote control, How to use the remote control, Installing batteries – Sharp AF-08ERL User Manual

Page 16

Advertising
background image

16

HOW TO OPERATE

INSTALLING BATTERIES

Use two size-AA (R6) batteries.

Battery compartment cover

NOTES:
• The battery life is approximately one year with normal use.
• When you replace the batteries, always use two new ones of the same type.
• If the remote control does not operate normally after replacing the batteries, take out the

batteries and replace them again after 30 seconds.

• If you will not be using the unit for a long time, remove the batteries from the remote control.

HOW TO USE THE REMOTE CONTROL

Point the remote control towards the unit's re-
ceiver window and press the desired button. A
beep will sound when the unit receives the signal.

• Make sure no objects, such as curtains, block the

receiver window.

• The remote control operates from up to 20 feet (6

meters) away.

• The beep will also sound when each pad on the

control panel is touched.

CAUTION:
• Do not expose the receiver window to direct sunlight. This can adversely affect its operation. In

such case, close the curtains to block the sunlight.

• Use of a fluorescent lamp in the same room may interfere with the transmission of the signal.
• The unit may be affected by signals emitted from the remote control of a television, VCR or other

equipment used in the same room.

• Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote

control from moisture and shock which can discolor or damage it.

2

1

3

USING THE REMOTE CONTROL

Open the battery compartment
cover.

Insert and slide the batteries into
the compartment, making sure
the and polarities are
properly aligned.

Close the cover.

Advertising