Salton, Inc FOOTBATH FM14W - Manual (Page 8)

HOW TO USE YOUR FOOTBATH
1. Remove Footbath and all accessories from box.
2. Remove plastic covering from plug and unwrap cord.
IMPORTANT: Ensure that the unit is unplugged before filling with
water. Do not fill past the MAX fill line.
3. Fill Footbath with 1.5 inches of warm water. Do not overfill.
4. Select the Massage Center Attachment that you wish to use and
place it in the Massage Center.
5. Place Footbath at the base of a sturdy chair and plug into standard
120V electrical outlet.
NOTE: Footbath will only maintain the temperature of the
water used. It will not heat cold water. For a warm water
massage, please fill the unit with warm water.
NOTE: Heat should be pleasant and comfortable. Should
pain or discomfort result, discontinue use and consult
your physician.
NOTE: Do not use unit for more than 20 minutes at a time.
6. Turn the Function Dial to indicate the massage of your choice:
0 = OFF
1 = Massage
2 = Massage + Heat
7. Sit in a sturdy chair and slowly place your feet in Footbath.
8. Enjoy massage. Enhance your massage experience by slowly
rubbing your feet along the Massage Rollers.You may massage
specific areas of your feet with the Massage Node.
9. When finished, turn Control Dial to OFF and unplug the unit. Hold
unit over capable drain and tip the Footbath, allowing water to spill
out along one of the Drainage Grooves. NEVER allow water to
come into contact with the Control Dial.
7 4
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for the current, and will
reduce the risk of electrical shock.The plug must be plugged into an
appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER! Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the product
is properly grounded. Do not modify the Plug provided with the product
— if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
This product is for use on a normal 120-volt circuit and has a
grounding plug that looks like the plug illustrated in the Figure 1.
However, a temporary adapter that looks like the adapter illustrated in
Figures 2 and 3 may be used to connect this plug to a 2-pole
receptacle as shown in Figure 2 if a properly grounded outlet is not
available.The temporary adapter should be used only until a properly
grounded outlet (Figure 1) can be installed by a qualified electrician.The
green colored rigid ear, lug or the like extending from the adapter must
be connected to a permanent ground such as a properly grounded
outlet box cover.Whenever the adapter is used, it must be held in place
by a metal screw.
Grounding
Pin
Grounded
Outlet
Metal
Screw
Figure 1
Figure 2
Figure 3
Adapter
For Grounding
Screw
Relaxor_FM14W,B,G,P_IB 12/20/02 3:34 PM Page 9