Samson MDR10 - Manual (Page 24)

22
MDR10 Specifications
Normal Limit
Frequency Response (Trim @ Min, unity gain ± 3 dB)
Mic to Main 15 Hz - 54 kHz 20 Hz - 50 kHz
Line to Main 5 Hz - 70 kHz
Aux Return to Main 5 Hz - 98 kHz
Line to Aux Send 5 Hz - 57 kHz
T.H.D. (Trim @ Min, +4dBu output, unity gain, 1 kHz w/30 kHz LPF)
Mic/Line to Main (Mono Ch) 0.02% 0.05%
Line to Main (Stereo Ch) 0.02% 0.05%
Line to Aux Send 0.02% 0.05%
Equivalent Input Noise ("A" filter on, input shorted)
Mic -128 dB -128 dB
Line -104 dB
Maximum Voltage Gain
Mic to Main 85 dB
Line to Main (Mono Ch) 50 dB
Line/Tape to Main (Stereo Ch) 20 dB
Aux Return to Main 20 dB
Mic to Aux Send 74 dB
Line to Aux Send (Stereo Ch) 41 dB
Residual Noise (30 kHz LPF, all control Min)
Main -96 dBu -85 dBu
Aux Send -82 dBu -82 dBu
Crosstalk (@ 1 kHz w/ 30 kHz LPF)
Ch vs. Ch 75 dB 70 dB
Input vs. Output 87.5 dB 80 dB
Peak LED Sensitivity (before clipping) 3 dB 5 ± 2dB
CLIP Indicators Turn on: THD> 0.1%
Headphone output (600 ohm load) 100 mW 90 mW min.
Maximum Input Level (1 kHz, ± 3dB)
Mic Input (Mono Ch) -8 dBu
Line Input (Mono Ch) +27 dBu
Input Channel Equalizer (± 2dB)
High (shelving) 12 kHz ±15 dB
Mid (peaking) Variable 100Hz - 5 kHz ± 15 dB
Low (shelving) 80 Hz ±15 dB
Meters 12 POINT LED METERS (-21, -18, -16, -12,
-9, -6, -3, 0, +6, +9, +20)
Internal DSP Effects 24 BIT -8 presets: 1 - Large Hall; 2 Medium
Hall, 3 - Large Room; 4 - Vocal Room 1; 5 -
Vocal Room 2; 6 - Chorus + Reverb; 7 -
Chorus + Delay; 8 - Stairwell
Phantom Power +48V
Power Requirement 110V-240V, 50/60Hz
Power Consumption 50W
Dimensions (W x D x H) 16.25” x 16.25” x 3.75” (41.3cm x 41.3cm x
9.5cm)
Weight 7.5 lbs. (3.4 kg )